Product: eSUN PLA Photopolymer Resin for LCD 3D printers, eResin-PLA
Compatible with our CREALITY3D LD002R resin 3d printers and other resin 3d printers. Packaged in a durable aluminum bottle.
Solidify wavelength: 395nm to 405nm
Hardness (D): 75D
Viscosity (25C,mPa.s): 250 to 350 mpa.s
Density: 1.10 to 1.11 g / cm3
Shrinkage of Vol.: 5.52%-5.97%
Flexural strength (Mpa): 50Mpa to 55Mpa
Flexural Modulus (Mpa): 1.61 to 2.56
Tensile strength (Mpa): 40Mpa to 50 Mpa
Elongation at break (%): 32% to 40%
Notched impact strength (J/m): 90 to 97
Hardness (D): 75D
1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
Avoid any dusty or moist environment.
1) Shake well before use. Avoid any direct sunlight during usage.
2) Keep it away from the children. Do not put in mouth.
3) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.
4) If accidentally contacted, please wash with plenty of water immediately. Seek medical advice if necessary.
5) Finished models are required to clean by high-concentration alcohol (>95%) about 30 seconds.
Before choosing eSUN resins for your LCD 3D printers, please confirm that the UV wavelength of your 3D printer is 405nm. Thoroughly tested and perfectly compatible to Creality3D LD002R, EPAX X1, Anycubic Photon and Wanhao D7.
Bottom Exposure Time: 30-50s when layer thickness is 0.05mm, recommend set to 40s.
Normal Exposure Time: 6-10s when layer thickness is 0.05mm, recommend set to 7s on EPAX X1 or 10 seconds on Anycubic Photon.
PS: Exposure time is proportional to layer thickness. The numbers above are for layer thickness 0.05mm。if thickness is 0.1mm, the normal exposure time will be 12-20s. If layer thickness is 0.02 then the normal exposure time is 2-4s.
You might also like