eSUN Muti-Colour Water Washable Resin for LCD 3D Printers, 1000g

Product: eSUN Water Washable Resin for LCD 3D Printers

Size: 1000g/bottle

Specifically designed for LCD/LED light source to achieve better printing quality.

Water Washable Hard Resin, Compatible with most LCD printers using 405 nm wavelength light

Instead of using IPA to clean up the prints, you can use tap water to wash the prints.  Note that you still need to leave the water outside under sunlight to cure any resins.  Don't drain to sink directly.

Faster Printing Speed

Low Odor

Compatible with our CREALITY3D LD002R resin 3d printers and other resin 3d printers. Packaged in a durable aluminium bottle.

Parameters:

Solidify wavelength: 395nm to 405nm

Hardness (D): 75D

Viscosity (25C,mPa.s): 110-180 mpa.s

Density: 1.10 to 1.11 g / cm3

Shrinkage of Vol.: 5.52%-5.97%

Physical Properties:

Flexural strength (Mpa): 50Mpa to 55Mpa

Flexural Modulus (Mpa): 1.61 to 2.56

Tensile strength (Mpa): 40Mpa to 50 Mpa

Elongation at break (%): 32% to 40%

Notched impact strength (J/m): 90 to 97

Hardness (D): 75D

Precautions:

1. Storage

1) Keep away from light and sealed at room temperature.

2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.

Avoid any dusty or moist environment.

2. Usage:

1) Shake well before use. Avoid any direct sunlight during usage.

2) Keep it away from the children. Do not put it in your mouth.

3) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.

4) If accidentally contacted, please wash with plenty of water immediately. Seek medical advice if necessary.

5) Use tap water to clean finished models for about 30 seconds.

Before choosing eSUN resins for your LCD 3D printers, please confirm that the UV wavelength of your 3D printer is 405nm. Thoroughly tested and perfectly compatible with Creality3D LD002R, EPAX X1, Anycubic Photon and Wanhao D7.

Bottom Exposure Time: 30-the 50s when the layer thickness is 0.05mm, recommend set to 40s.

Normal Exposure Time: 6-10s when the layer thickness is 0.05mm, recommend set to 7s on EPAX X1 or 10 seconds on Anycubic Photon.

PS: Exposure time is proportional to layer thickness. The numbers above are for layer thickness of 0.05mm。 if the thickness is 0.1mm, the normal exposure time will be 12-20s. If layer thickness is 0.02 then the normal exposure time is 2-4s.