eSun DENTAL MODEL / MOLD resin for LCD/DLP 3D Printing Yellow,1kg

Please follow the link below for more information and Technical Data Sheet:

https://www.esun3d.com/dental-model-resin-product/

Parameter:

Viscosity(mPa·s): 150-300

Density(g/cm3): 1.05-1.25

Tensile Strength(MPa): 42-62

Elongation at Break(%): 10-20

Flexural Strength(MPa): 59-70

Impact Strength(J/m): 44-49

Hardness(Shore D): 80

How to Use: 

1) Shake well before use, prohibiting the use of resin in places where there is a lot of sunlight.

2) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.

3) Inadvertent contact, as soon as possible to use a lot of water rinse. If you feel unwell, seek timely medical attention.

4) Do not pour the resin in the resin vat into the unused resin, do not leave the resin in the resin vat for a long time without use to avoid resin pollution affect the printing effect.

How to Storage: 

1) Keep away from light seals at room temperature. (Sunshine contains a lot of UV light, will solidify photosensitive resin.)

2) It is recommended to store the resin under 15C -35℃ in a sealed container. Avoid any dusty or moist environment.

3) The resin is stable under different climatic conditions and is also easy to store, overcoming the shortcomings of other resins easily damp softening and environmental corrosion.

Safe Package: 

Thickened aluminum bottle completely protected from light. Leak-proof bottle fully wrapped with a plastic bubble bag to make sure the resin stays in place where they belong.