Wham Bam PEX Build Surfaces - 258mm*258mm
Auckland Local Stock
The Wham Bam PEX Build Surface was developed from a specially formulated polymer with a higher melt point than PEI that attracts most any filament without damaging the sheet. Prints easily pop off once cooled and flexed. The PEX build surface is 0.35mm thick and pre-backed with 3M adhesive so it takes seconds to install.
Feel free to enquire about the product.
PEX Build Surface - 258 x 258mm
Compatible with Bambu Lab X1, X1 Carbon (or X1C), X1E, P1P, and P1PS